2024-07-23

Lightbar - Front (Remove and Install)

Correction code 1740056011 FRT 0.12 NOTE: Unless otherwise explicitly stated in the procedure, the correction code and FRT listed above reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. NOTE: See Personal Protection to make sure you are wearing proper PPE when performing the procedure below. NOTE: See Ergonomic Precautions for safe and healthy working practices.

Warning IconA warning icon, calling your attention to a possibly risky situation
Warning
This procedure is a DRAFT. Although it has been validated, Warnings and Cautions might be missing. Follow safety requirements and use extreme caution when working on or near High Voltage systems and components.

Remove

  1. Remove the powergate fascia assembly. See Powergate Fascia (Remove and Install).
  2. Disconnect the electrical connector, and then remove the nuts (x2) and bolts (x2) that attach the lightbar to the powergate.
  3. Pull the lightbar forward to release the clips (x3) and datums (x3) to remove it from the vehicle.
    Informational PurposesAn informational icon, calling your attention
    Note
    Make sure the harness does not get caught during removal.

Install

  1. Position the lightbar onto the powergate, and then secure the clips (x3) and datums (x3).
    Warning IconA warning icon, calling your attention to a possibly risky situation
    CAUTION
    Make sure the harness does not get pinched during installation.
    Informational PurposesAn informational icon, calling your attention
    Note
    Push the lightbar rearwards to engage the clips.
  2. Install the nuts (x2) and bolts (x2) that attach the lightbar to the powergate, and then connect the electrical connector.
    3 Nm (2.2 lbs-ft)
    4 Nm (2.9 lbs-ft)
    Informational PurposesAn informational icon, calling your attention
    Note
    The nuts are torqued to 3 Nm and the bolts are torqued to 4 Nm.
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • 10 mm socket
  3. Install the powergate fascia assembly. See Powergate Fascia (Remove and Install).