2025-07-07

BLE End Point - Wheel Well - Rear - RH (Remove and Install)

Correction code 1745104081 0.18 NOTE: Unless otherwise explicitly stated in the procedure, the correction code and FRT listed above reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. NOTE: See Personal Protection to make sure you are wearing proper PPE when performing the procedure below. NOTE: See Ergonomic Precautions for safe and healthy working practices.

Warning IconA warning icon, calling your attention to a possibly risky situation
Warning
This procedure is a DRAFT. Although it has been validated, Warnings and Cautions might be missing. Follow safety requirements and use extreme caution when working on or near High Voltage systems and components.
  1. Open the LH front door and lower the LH front window.
  2. Place the vehicle into Service Mode. See Service Mode.
  3. Remove the RH rear fore fender flare. See
    Informational PurposesAn informational icon, calling your attention
    Note
    12 clips, 9x tabs
  4. Remove clips securing LH rear wheel liner to fore fender flare carrier
    Informational PurposesAn informational icon, calling your attention
    Note
    5x clips
  5. Remove LH rear fore fender flare carrier
    Informational PurposesAn informational icon, calling your attention
    Note
    6x bolts, 10mm, 7 Nm, 1x connector, Disconnect BLE module then remove carrier, Release locking tab
  6. Remove LH rear wheel well BLE endpoint
    Informational PurposesAn informational icon, calling your attention
    Note
    2x bolts, T20, 1.5 Nm, Discard bolts
  7. Install LH rear wheel well BLE endpoint
    Informational PurposesAn informational icon, calling your attention
    Note
    2x bolts, T20, 1.5 Nm, Install new bolts
  8. Install LH rear fore fender flare carrier
    Informational PurposesAn informational icon, calling your attention
    Note
    6x bolts, 10mm, 7 Nm, 1x connector, Connect BLE then install carrier, Engage locking tab
  9. Install clips securing LH rear wheel liner to fore fender flare carrier
    Informational PurposesAn informational icon, calling your attention
    Note
    5x clips
  10. Install LH rear fore fender flare
    Informational PurposesAn informational icon, calling your attention
    Note
    12 clips, 9x tabs, Replace any damaged or missing clips
  11. Exit Service Mode. See Service Mode.
  12. Raise the LH front window and close the LH front door.