23/07/2024 17:30:46

Headlight - Adjust (Wall Method)

Correction code 17400100 FRT 0.10 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.

Warning IconA warning icon, calling your attention to a possibly risky situation
Warning
This procedure is a DRAFT. Although it has been validated, Warnings and Cautions might be missing. Follow safety requirements and use extreme caution when working on or near High Voltage systems and components. Provide corrections and feedback to ServiceDevelopment@teslamotors.com.

Procedure

  1. Apply a piece of tape to wall 26 inches (66.1cm) from the ground.
  2. Apply tape to floor 25 feet (7.6m) from the wall.
  3. Park the vehicle on a flat level surface perpendicular to wall and align the front fascia with tape on the floor.
    Informational PurposesAn informational icon, calling your attention
    Note
    Choose a dark work area with low ambient lighting for best results. Make sure the tire pressure is set to specification.
  4. Open the LH front door and lower the LH front window.
  5. Using the center display, navigate to Controls > Suspension > Medium to set the air suspension to medium height.
  6. Using the center display, navigate to Controls > Service > Jack Mode to place the vehicle in Jack Mode.
  7. Using the center display, navigate to Controls > Service > Adjust Headlamps to enter headlight adjustment mode.
    Informational PurposesAn informational icon, calling your attention
    Note
    Vehicle will automatically perform headlight calibration
  8. Completely cover the LH headlight.
  9. Select Right, and then use the left scroll wheel on the steering wheel to adjust the beam level.
    Informational PurposesAn informational icon, calling your attention
    Note
    Do not sit in the vehicle during adjustment as this will affect headlamp height.
    Informational PurposesAn informational icon, calling your attention
    Note
    Adjust the RH headlight so that top of horizontal beam aligns with tape mark on the wall, and the left edge of the L-shaped beam aligns with RH reference tape.
  10. Remove the cover from the LH headlight then completely cover the RH headlight.
  11. Select Left, and then use the left scroll wheel on the steering wheel to adjust the beam level.
    Informational PurposesAn informational icon, calling your attention
    Note
    Do not sit in the vehicle during adjustment as this will affect headlamp height.
    Informational PurposesAn informational icon, calling your attention
    Note
    Adjust LH headlight so that top of horizontal beam aligns with tape mark on wall, and the left edge of the L-shaped beam aligns with LH reference tape.
  12. Exit the headlight adjustment mode from the center display.
  13. Raise the LH rear window and close the LH rear door.