2024-07-23
Jumper Duct - Center Console (Remove and Install)
Correction code
1810084101
1810084102
FRT
0.90
NOTE: Unless otherwise explicitly stated in the procedure, the correction code and FRT listed above reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so.
NOTE: See Flat Rate Times to learn more about FRTs and how they are created.
NOTE: See Personal Protection to make sure you
are wearing proper PPE when performing the procedure below.
NOTE: See Ergonomic Precautions for safe and healthy working practices.
Warning
This procedure is a DRAFT.
Although it has been validated, Warnings and Cautions might be missing. Follow safety
requirements and use extreme caution when working on or near High Voltage systems and
components.
Remove
- Remove the center console riser duct. See Riser Duct - Center Console (Remove and Install).
-
Slide the floor jumper duct forward to
release it from the center console riser duct, and then lift the rear of the jumper duct
and pull rearward to remove it.
Install
-
Position the floor jumper duct into the vehicle, and then slide the front of the duct
into position.
- Install the center console riser duct. See Riser Duct - Center Console (Remove and Install).