2025-02-21

2nd Row Outboard Front A-Cover - LH (Remove and Replace)

Correction code 1308005141, 1308005142 0.12 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.

Warning IconA warning icon, calling your attention to a possibly risky situation
Warning
This procedure is a DRAFT. Although it has been validated, Warnings and Cautions might be missing. Follow safety requirements and use extreme caution when working on or near High Voltage systems and components. Provide corrections and feedback to ServiceDevelopment@teslamotors.com.
  1. Open LH rear door
    Informational PurposesAn informational icon, calling your attention
    Note
    Push LH C-pillar door trigger to release
  2. Lower LH rear window
  3. Partially release LH rear primary door seal
  4. Remove LH lower C-pillar trim
    Informational PurposesAn informational icon, calling your attention
    Note
    3x clips, 7x tabs, 4x datums, Starting at door sill pull upward then forward to release, Leave trim attached to seat belt
  5. Remove 2nd row seatback LH outboard bolster
    Informational PurposesAn informational icon, calling your attention
    Note
    2x tabs, 1x datum, 3x clips, Release tab near the bottom of LH outboard bolster, Partially release LH 2nd row shoulder cover and remove bolster from vehicle
  6. Fold up 2nd row 60 seat
    Informational PurposesAn informational icon, calling your attention
    Note
    Pull tether to release then lift up until locked in place
  7. Remove LH 2nd row seat cushion outboard cover
    Informational PurposesAn informational icon, calling your attention
    Note
    1x clip, Pull outward from lower forward section to release
  8. Install LH 2nd row seat cushion outboard cover
    Informational PurposesAn informational icon, calling your attention
    Note
    1x clip, Pull outward from lower forward section to release
  9. Fold down 2nd row 60 seat
    Informational PurposesAn informational icon, calling your attention
    Note
    Pull tether to release then pivot down until locked in place
  10. Install 2nd row seatback LH outboard bolster
    Informational PurposesAn informational icon, calling your attention
    Note
    2x tabs, 1x datum, 3x clips, Position LH outboard bolster into place, Ensure all clips and tabs are fully engaged, Replace any missing or damaged clips, Secure LH 2nd row shoulder cover, Perform push-pull-push test
  11. Install LH lower C-pillar tr
    Informational PurposesAn informational icon, calling your attention
    Note
    3x clips, 7x tabs, 4x datums
  12. Secure LH rear primary door seal
  13. Raise LH rear window
  14. Close LH rear door