2024-07-23

Module (RJ45) - Ethernet Diagnostic (Remove and Install)

Correction code 1405028021 1405028022 FRT 0.12 NOTE: Unless otherwise explicitly stated in the procedure, the correction code and FRT listed above reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. NOTE: See Personal Protection to make sure you are wearing proper PPE when performing the procedure below. NOTE: See Ergonomic Precautions for safe and healthy working practices.

Warning IconA warning icon, calling your attention to a possibly risky situation
Warning
This procedure is a DRAFT. Although it has been validated, Warnings and Cautions might be missing. Follow safety requirements and use extreme caution when working on or near High Voltage systems and components.

Remove

  1. Open the LH front door and lower the LH front window.
  2. Open the RH front door and lower the RH front window.
  3. Remove the footwell cover. See Cover - Footwell (Remove and Install).
  4. Release the clips (x2) that attach the Ethernet diagnostic module to the vehicle, release the connector lock and disconnect the electrical connector, and then remove the module from the vehicle.
    Informational PurposesAn informational icon, calling your attention
    Note
    The Ethernet diagnostic port is located in the RH footwell.

Install

  1. Position the Ethernet diagnostic module into the vehicle, connect the electrical connector and engage the connector lock, and then secure the clips (x2) that attach the module to the vehicle.
    Informational PurposesAn informational icon, calling your attention
    Note
    The Ethernet diagnostic port is located in the RH footwell.
  2. Install the footwell cover. See Cover - Footwell (Remove and Install).
  3. Raise the RH front window and close the RH front door.
  4. Raise the LH front window and close the LH front door.