2024-07-23

Aero Seal - LH - Powergate (Remove and Install)

Correction code 1170085011 1170085012 1170085021 1170085022 FRT 0.12 NOTE: Unless otherwise explicitly stated in the procedure, the correction code and FRT listed above reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. NOTE: See Personal Protection to make sure you are wearing proper PPE when performing the procedure below. NOTE: See Ergonomic Precautions for safe and healthy working practices.

Warning IconA warning icon, calling your attention to a possibly risky situation
Warning
This procedure is a DRAFT. Although it has been validated, Warnings and Cautions might be missing. Follow safety requirements and use extreme caution when working on or near High Voltage systems and components.

Remove

  1. Open the powered frunk.
  2. Release the clips (x8) that attach the LH powered front truck aeroseal to the vehicle, and then remove the seal from the vehicle.
    Informational PurposesAn informational icon, calling your attention
    Note
    Remove any residual adhesive from the powered frunk and aeroseal if reusing.

Install

  1. Position the LH powered front truck aeroseal to the vehicle, and then secure the clips (x8) that attach the seal to the vehicle..
    Informational PurposesAn informational icon, calling your attention
    Note
    Wipe the aeroseal and powered front trunk where the double sided tape will be applied with IPA wipes. Allow IPA 1 minute to dry. Apply new double sided tape to aeroseal.
    Informational PurposesAn informational icon, calling your attention
    Note
    Replace any missing or damaged clips.
  2. Close the powered frunk.