2026-08-09

Front Subframe - Recovery Hook - LH (Remove and Replace)

Correction code NA NOTE: Unless otherwise explicitly stated in the procedure, the correction code and its associated FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. NOTE: See Personal Protection to make sure you are wearing proper PPE when performing the procedure below. NOTE: See Ergonomic Precautions for safe and healthy working practices.

Warning
This procedure is a DRAFT. Although it has been validated, Warnings and Cautions might be missing. Follow safety requirements and use extreme caution when working on or near High Voltage systems and components.

Remove

  1. Remove the front fascia assembly. See Front Fascia (Remove and Install).
  2. Remove and discard the bolts (x4) that attach the LH recovery hook to the vehicle, and then slide the recovery hook out and away from the subframe to remove it from the vehicle.
    78 Nm (57.5 lbs-ft)
    Tip
    Use of the following tool(s) is recommended:
    • 15 mm socket

Install

  1. Slide the LH recovery hook toward the subframe to position it into the vehicle, and then install new bolt (x4) that attach the hook to the vehicle.
    78 Nm (57.5 lbs-ft)
    Tip
    Use of the following tool(s) is recommended:
    • 15 mm socket
  2. Install the front fascia assembly. See Front Fascia (Remove and Install).