Closure Panels - Assembly - Powergate Fascia (Remove and Install)
Correction code 1010025131 FRT 0.12 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.
- 2024-05-13: Added steps to remove/install lightbar beauty covers, and steps to align locator pin.
Remove
- Open the LH front door and lower the LH front window.
- Open the powered frunk.
- Remove the LH and RH lightbar beauty covers. See Exterior Trim Fittings - Lightbar Beauty Cover - LH (Remove and Install).
-
Remove the bolts (x12) that attach the
powergate fascia to the powergate assembly, and then pull the fascia straight away from
the powergate assembly to remove it.Tip: Use of the following tool(s) is recommended:
- 10 mm socket
Install
-
Position the powergate fascia onto the vehicle, align the locator pin at the center
of the fascia to the powergate assembly, and then press the fascia into position.
-
Install the bolts (x12) that attach
the fascia to the powergate.Tip: Use of the following tool(s) is recommended:
- 10 mm socket
- Install the LH and RH lightbar beauty covers. See Exterior Trim Fittings - Lightbar Beauty Cover - LH (Remove and Install).
- Close the powered frunk.
- Raise the LH front window and close the LH front door.