Waist Belt Seal - Inner - Rear Door - LH (Remove and Install)
Correction code
1170042111
1170042112
1170042121
1170042122
FRT
0.06
NOTE: Unless
otherwise explicitly stated in the procedure, the correction code and FRT
listed above reflect all of the work required to perform this procedure,
including the linked procedures. Do not stack correction
codes unless explicitly told to do so.
NOTE: See Flat Rate Times
to learn more about FRTs and how they are created.
NOTE: See Personal Protection
to make sure you are wearing proper PPE when performing the procedure
below.
NOTE:
See Ergonomic Precautions for
safe and healthy working practices.
Remove
- Open the LH rear door and lower the LH rear window.
- Remove the LH rear beltline assembly. See Beltline Assembly - Door Panel - Rear - LH (Remove and Install).
-
Release the rubber grommets (x7) on
each end of the LH rear door inner waist belt seal, and then lift the seal upwards to
remove it from the door assembly.
Install
-
Position the LH rear door inner waist
belt seal onto the door assembly, and then secure the grommets (x7) on both ends.
- Install the LH rear door beltline assembly. See Beltline Assembly - Door Panel - Rear - LH (Remove and Install).
- Raise the LH front window and close the LH front door.