23/07/2024 17:32:39

Passenger Ducting and Vents - Quarter Glass Demist Duct, LH (Remove and Install)

Correction code 1810084141 1810084142 FRT 0.54 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.

Warning IconA warning icon, calling your attention to a possibly risky situation
Warning
This procedure is a DRAFT, although it has been validated. Warnings and Cautions might be missing. Follow safety requirements and use extreme caution when working on or near high voltage systems and components. Provide corrections and feedback to ServiceDevelopment@teslamotors.com.

Remove

  1. Remove the lower instrument panel assembly. See Dash Panel - Instrument Panel Lower Assembly (Remove and Install).
  2. Remove the glovebox assembly. See Dash Panel - IP Glovebox Assembly (Remove and Install).
  3. Remove the RH air wave duct. See Passenger Ducting and Vents - Panel Duct, RH (Remove and Install).
  4. Remove the front passenger airbag. See Front Air Bags - MX - Passenger Airbag, NAR (Remove and Install).
  5. Remove the instrument panel top pad assembly. See Dash Panel - Instrument Panel Top Pad Assembly (Remove and Install).
  6. Remove the LH IP quarter panel. See Dash Panel - Quarter Panel Assembly - LH (Remove and Install).
  7. Release the clip that attaches the LH quarter glass demist duct to the vehicle, and then remove the duct from the vehicle.

Install

  1. Position the LH quarter glass demist duct into the vehicle, and then secure the clip that attaches the duct to the vehicle.
    Informational PurposesAn informational icon, calling your attention
    Note
    Make sure the duct is seated correctly.
  2. Install the LH IP quarter panel. See Dash Panel - Quarter Panel Assembly - LH (Remove and Install).
  3. Install the instrument panel top pad assembly. See Dash Panel - Instrument Panel Top Pad Assembly (Remove and Install).
  4. Install the front passenger airbag. See Front Air Bags - MX - Passenger Airbag, NAR (Remove and Install).
  5. Install the RH air wave duct. See Passenger Ducting and Vents - Panel Duct, RH (Remove and Install).
  6. Install the glovebox assembly. See Dash Panel - IP Glovebox Assembly (Remove and Install).
  7. Install the lower instrument panel assembly. See Dash Panel - Instrument Panel Lower Assembly (Remove and Install).