11/09/2024 15:18:25

Truck Bed - Bed Floor Assembly (Remove and Install)

Correction code 1215125021 1215125022 FRT 0.12 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.

  • 2024-09-11: Added cautions to note and correctly install shorter fasteners at the front of the bed floor assembly.
Warning IconA warning icon, calling your attention to a possibly risky situation
Warning
This procedure is a DRAFT. Although it has been validated, Warnings and Cautions might be missing. Follow safety requirements and use extreme caution when working on or near High Voltage systems and components. Provide corrections and feedback to ServiceDevelopment@teslamotors.com.

Remove

  1. Open the tonneau cover.
  2. Open the tailgate.
  3. Remove the fastener covers (x10) from the bed floor assembly.
  4. With assistance, remove the bolts (x10 ) that attach the bed floor assembly to the vehicle, and then remove the assembly from the vehicle.
    56 Nm (41.3 lbs-ft)
    Informational PurposesAn informational icon, calling your attention
    Note
    Lift the front edge with trim tool, and then remove the panel.
    Warning IconA warning icon, calling your attention to a possibly risky situation
    CAUTION
    The bolts (x4) at the front of the vehicle are shorter than the middle and rear bolts. Note the bolt location when removing them from the vehicle.
    Tip: Use of the following tool(s) is recommended:
    • 15 mm socket

Install

  1. With assistance, position the bed floor assembly into the vehicle, and then install the bolts (x10 ) that attach the assembly to the vehicle.
    56 Nm (41.3 lbs-ft)
    Warning IconA warning icon, calling your attention to a possibly risky situation
    CAUTION
    Make sure the bolts (x4) at the front of the front of the assembly are shorter than the middle and rear bolts. Incorrectly installing the longer bolts at the front of the assembly may cause the tonneau cover to bind and may damage components.
    Tip: Use of the following tool(s) is recommended:
    • 15 mm socket
  2. Install the fastener covers (x10) from the bed floor assembly.
  3. Close the tonneau cover.
  4. Close the tailgate.