Puddle Lamp - Footwell - Instrument Panel (Remove and Install)
Correction code
1405027011
1405027012
FRT
0.12
NOTE: Unless
otherwise explicitly stated in the procedure, the above correction code and
FRT reflect all of the work required to perform this procedure, including
the linked procedures. Do
not stack correction codes unless explicitly told to do so.
NOTE: See Flat Rate Times to learn more about FRTs and how they are
created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com.
NOTE: See Personal Protection to make
sure wearing proper PPE when performing the below procedure.
Remove
- Open the LH front door and lower the LH front window.
- Remove the footwell cover. See Cover - Footwell (Remove and Install).
- Release the LH side footwell lamp from the lower IP panel, disconnect the electrical connector, and then remove the lamp from the vehicle.
Install
- Position the LH side footwell lamp to the lower IP panel, connect the electrical connector, and then secure the lamp to the lower IP panel.
- Install the footwell cover. See Cover - Footwell (Remove and Install).
- Raise the LH front window and close the LH front door.