23/07/2024 17:25:37

Audio Speakers - Audio Speaker Super Horn (Remove and Install)

Correction code 2121012041 FRT 0.12 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.

Warning IconA warning icon, calling your attention to a possibly risky situation
Warning
This procedure is a DRAFT. Although it has been validated, Warnings and Cautions might be missing. Follow safety requirements and use extreme caution when working on or near High Voltage systems and components. Provide corrections and feedback to ServiceDevelopment@teslamotors.com.

Remove

  1. Open the LH front door and lower the LH front window.
  2. Set the air suspension ride height to “Very High”.
    Informational PurposesAn informational icon, calling your attention
    Note
    On the center display, navigate to Controls > Suspension > ''Very High'.'
  3. Release the clips (x4) that attach the front portion of the RH front wheel house liner to the vehicle.
  4. Release the clip that attaches the Superhorn harness to the vehicle, and then release the locking tab and disconnect the electrical connector.
  5. Remove the screws (x3) that attach the Superhorn to the vehicle, and then remove the horn from the vehicle.
    2 Nm (1.5 lbs-ft)
    Tip: Use of the following tool(s) is recommended:
    • Torx T25 bit

Install

  1. Position the Superhorn into the vehicle, and then install the screws (x3) that attach the horn to the vehicle.
    2 Nm (1.5 lbs-ft)
    Tip: Use of the following tool(s) is recommended:
    • Torx T25 bit
  2. Connect the Superhorn electrical connector, secure the connector lock, and then install the clip that attaches the harness to the vehicle.
  3. Move the front portion of the RH front wheel house liner into position, and then install the clips (x4) that attach the liner to the vehicle.
  4. Return the air suspension setting to "Standard".
    Informational PurposesAn informational icon, calling your attention
    Note
    On the vehicle touch screen, navigate to Controls > Suspension > ''Standard''.
  5. Raise the LH front window and close the LH front door.