23/07/2024 17:29:13

Front Bumper Fascia - Front Fascia Fairing Assembly - LH (Remove and Install)

Correction code 1001046011 FRT 0.12 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.

Warning IconA warning icon, calling your attention to a possibly risky situation
Warning
This procedure is a DRAFT, although it has been validated. Warnings and Cautions might be missing. Follow safety requirements and use extreme caution when working on or near high voltage systems and components. Provide corrections and feedback to ServiceDevelopment@teslamotors.com.

Remove

  1. Open the LH front door and lower the LH front window.
  2. Set the air suspension ride height to “Very High”.
    Informational PurposesAn informational icon, calling your attention
    Note
    On the center display, navigate to Controls > Suspension > ''Very High'.'
  3. Release the clips (x4) that attach the front portion of the LH front wheel house liner to the vehicle.
  4. Remove the nuts (x2) that attach the LH front fascia fairing to the vehicle, and then pull the fairing downward to release the clips (x3).
    4 Nm (2.9 lbs-ft)
    Tip: Use of the following tool(s) is recommended:
    • 10 mm socket

Install

  1. Position the LH front fascia fairing to the vehicle, push the fairing upward to engage the clips (x3), and then install the nuts (x2) that attach the fairing to the vehicle.
    4 Nm (2.9 lbs-ft)
    Tip: Use of the following tool(s) is recommended:
    • 10 mm socket
  2. Move the LH wheel liner into position, and then install the clips (x4) that attach the liner to the vehicle.
  3. Return the air suspension to "Standard".
    Informational PurposesAn informational icon, calling your attention
    Note
    Using the center display, navigate to Controls > Suspension > ''Standard''.
  4. Raise the LH front window and close the LH front door.