31/10/2023 14:22:33

Dash Panel - IP Mid Panel Assembly (Remove and Install)

Correction code 1405027031 FRT 0.06 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.

Warning

This procedure is a DRAFT, although it has been validated. Warnings and Cautions might be missing. Follow safety requirements and use extreme caution when working on or near high voltage systems and components. Provide corrections and feedback to ServiceDevelopment@teslamotors.com.

Remove

Open the front doors and lower the front windows.
Remove the LH mid A-pillar trim. See A-B-C Positivet Interior Trim - A-Pillar Mid Trim - LH (Remove and Install).
Release the clips (x19) that attach the mid instrument panel to the vehicle, and then remove the panel from the IP.

Install

Position the mid instrument panel into the vehicle, and then install the clips (x19) that attach the panel to the IP.

Note
Replace any missing or damaged clips.
Install the LH mid A-pillar trim. See A-B-C Positivet Interior Trim - A-Pillar Mid Trim - LH (Remove and Install).
Raise the front windows and close the front doors.