Correction code 1520068081 FRT 0.06 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.

1. Remove the front header trim. See Headliner Trim - Front Header Trim (Remove and Install).
2. Disconnect the connectors (x2) from the telematics control unit, release the clips (x4) that attach the control unit to the header trim, and then remove the control unit from the assembly.
   Note

   Release the connector locks before disconnecting the connectors.

   

   

3. Remove the screws (x2) that attach the telematics control unit bracket to the control unit, and then release the clips (x2) to remove the bracket from the control unit.
   

   3 Nm (2.2 lbs-ft)
   TIp

   Use of the following tool(s) is recommended:

   • Torx T30 socket

   

   

   

   

4. Position the telematics control unit bracket to the control unit, install the clips (x2) that attach the bracket to the control unit, and then install the screws (x2).
   

   3 Nm (2.2 lbs-ft)
   TIp

   Use of the following tool(s) is recommended:

   • Torx T30 socket

   

   

5. Position the telematics control unit assembly to the front header trim, connect the connectors (x2), and then secure the clips (x4) that attach the control unit to the header trim.
   Note

   Engage the connector locks.

   Note

   Replace any missing or damaged clips.

   

   

   

6. Install the front header trim. See Headliner Trim - Front Header Trim (Remove and Install).