2026-02-20

Pretensioner - Lap - Driver (Remove and Install)

Correction code 2010086011 2010086012 2010086021 2010086022 FRT 0.12 NOTE: Unless otherwise explicitly stated in the procedure, the correction code and FRT listed above reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. NOTE: See Personal Protection to make sure you are wearing proper PPE when performing the procedure below. NOTE: See Ergonomic Precautions for safe and healthy working practices.

  • 2026-02-19: Added note on using PROC_RCM_DISARM if using this procedure to diagnose the SRS.
Warning IconA warning icon, calling your attention to a possibly risky situation
Warning
If using this procedure to diagnosis the vehicle's Supplemental Restraint Systems (SRS), disarm the RCM, which will prevent all airbags and pretensioners from deploying. Re-arm the RCM after all of the vehicle's SRS components are re-installed.
  • Disarm RCM:PROC_RCM_DISARMvia Service Mode Plus:
    • Safety & Restraints ➜ Airbags ➜ Disarm RCM
    • Safety & Restraints ➜ Seats ➜ Disarm RCM
    via Toolbox:(link)
  • Re-arm RCM:PROC_RCM_ARMvia Service Mode Plus:
    • Safety & Restraints ➜ Airbags ➜ Re-Arm RCM
    • Safety & Restraints ➜ Seats ➜ Re-Arm RCM
    via Toolbox:(link)

Remove

  1. Remove the LH 1st row outboard side shield. See Side Shield - Outboard - 1st Row Seat - LH (Remove and Install).
  2. Release the connector safety lock, and then disconnect the LH lap pretensioner electrical connector.
  3. Remove the bolt that attaches the LH lap pretensioner to the seat track, and then remove the pretensioner from the vehicle.
    40 Nm (29.5 lbs-ft)
    Informational PurposesAn informational icon, calling your attention
    Note
    Bolt is patched and held in place with a metal clip.
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • Torx T50 socket

Install

  1. Position the LH lap pretensioner onto the seat track, and then install the bolt.
    40 Nm (29.5 lbs-ft)
    Informational PurposesAn informational icon, calling your attention
    Note
    Align the guide pin onto the seat track.
    Informational PurposesAn informational icon, calling your attention
    Note
    The bolt is captive. Apply threadlock to captive bolt if reinstalling the pretensioner.
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • Torx T50 socket
  2. Connect the LH lap pretensioner electrical connector, and then secure the safety lock.
  3. Install the LH 1st row outboard side shield. See Side Shield - Outboard - 1st Row Seat - LH (Remove and Install).