23/07/2024 17:28:55

Front and Rear Garnish - Carrier - Front Fender Flare Aft - LH (Remove and Install)

Correction code 1220043081 FRT 0.12 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.

Warning IconA warning icon, calling your attention to a possibly risky situation
Warning
This procedure is a DRAFT. Although it has been validated, Warnings and Cautions might be missing. Follow safety requirements and use extreme caution when working on or near High Voltage systems and components. Provide corrections and feedback to ServiceDevelopment@teslamotors.com.

Remove

  1. Open the LH front door and lower the LH front window.
  2. Place the vehicle into Service Mode via the UI. See Service Mode.
  3. Release the clips (x11) and datums (x3) that attach the LH front fender flare cover to the vehicle, disconnect the electrical connector, and then remove the cover from the vehicle.
    Warning IconA warning icon, calling your attention to a possibly risky situation
    CAUTION
    The camera harness is very short. Make sure excess force is not exerted on the harness.
  4. Remove the push clips (x6) that attach the LH front wheel liner to the aft fender flare carrier.
  5. Remove the bolts (x3) that attach the LH front aft fender flare carrier to the vehicle, and then remove the fender flare from the vehicle.
    6 Nm (4.4 lbs-ft)
    Tip: Use of the following tool(s) is recommended:
    • 10 mm socket

Install

  1. Position the LH front aft fender flare carrier onto the vehicle, and then install the bolts (x3) that attach the fender flare to the vehicle.
    6 Nm (4.4 lbs-ft)
    Tip: Use of the following tool(s) is recommended:
    • 10 mm socket
  2. Install the push clips (x6) that attach the LH front wheel liner to the aft fender flare carrier.
  3. Position the LH front fender flare cover onto the vehicle, connect the electrical connector, and then secure the clips (x11) and datums (x3) that attach the cover to the vehicle.
    Warning IconA warning icon, calling your attention to a possibly risky situation
    CAUTION
    The camera harness is very short. Make sure excess force is not exerted on the harness.
    Informational PurposesAn informational icon, calling your attention
    Note
    Replace any missing or damaged clips.
  4. Unlock the vehicle gateway. See Gateway (Unlock).
  5. Clear camera calibration via Service UI.
    Informational PurposesAn informational icon, calling your attention
    Note
    In Service Mode, navigate to Driver Assist > Cameras > Clear Camera Calibration > Camera Input > ForwardFacing, and then touch Run
  6. Exit Service Mode. See Service Mode.
  7. Raise the LH front window and close the LH front door.