2024-07-23

Windshield Wipers and Motor - Hose Washer Wiper Windshield (Remove and Install)

Correction code 1750135011 1750135012 FRT 0.12 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.

  • 2024-04-02: Cleaned up topic.
Warning IconA warning icon, calling your attention to a possibly risky situation
Warning
This procedure is a DRAFT. Although it has been validated, Warnings and Cautions might be missing. Follow safety requirements and use extreme caution when working on or near High Voltage systems and components. Provide corrections and feedback to ServiceDevelopment@teslamotors.com.

Remove

  1. Open the LH front door and lower the LH front window.
  2. Open the powered frunk.
  3. Remove the rear underhood apron. See Underhood Trim - Rear Apron Assembly (Remove and Install).
  4. Remove the frunk assembly. See Frunk Assembly (Remove and Install).
  5. Remove the windshield wiper washer hose.
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • Pick Miniature Soft Grip, 90 degree tip, 6 in
    Informational PurposesAn informational icon, calling your attention
    Note
    x2 quick disconnect fittings
    Informational PurposesAn informational icon, calling your attention
    Note
    Pull the hose out of the washer fluid reservoir grooves.

Install

  1. Install the windshield wiper washer hose.
    Informational PurposesAn informational icon, calling your attention
    Note
    x2 quick disconnect fittings
    Informational PurposesAn informational icon, calling your attention
    Note
    Secure the hose in the washer fluid reservoir grooves.
  2. Install the frunk assembly. See Frunk Assembly (Remove and Install).
  3. Install the rear underhood apron. See Underhood Trim - Rear Apron Assembly (Remove and Install).
  4. Close the powered frunk.
  5. Raise the LH front window and close the LH front door.