23/07/2024 17:23:10

1st Row Seat Belts - Single Fastener Seatbelt Webguide (Remove and Install)

Correction code 2005001041 2005001042 FRT 0.72 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.

Warning IconA warning icon, calling your attention to a possibly risky situation
Warning
This procedure is a DRAFT. Although it has been validated, Warnings and Cautions might be missing. Follow safety requirements and use extreme caution when working on or near High Voltage systems and components. Provide corrections and feedback to ServiceDevelopment@teslamotors.com.

Remove

  1. Open all the doors and lower all the windows.
  2. Remove the rear underhood apron. See Underhood Trim - Rear Apron Assembly (Remove and Install).
  3. Disconnect MV power. See Disconnect MV Power.
  4. Remove the front header trim. See Headliner Trim - Front Header Trim (Remove and Install).
  5. Close the LH and RH visors and retract the LH and RH windshield shade assemblies.
  6. Remove the LH mid A-pillar trim. See A-B-C Post Interior Trim - A-Pillar Mid Trim - LH (Remove and Install).
  7. Remove the LH upper A-pillar trim. See A-B-C Post Interior Trim - A-Pillar Upper Trim - LH (Remove and Install).
  8. Partially release the LH side lower A-pillar primary seal.
  9. Remove the LH lower A-pillar trim. See A-B-C Post Interior Trim - A-Pillar Lower Trim - LH (Remove and Install).
  10. Move the LH front seat fully forward.
  11. Remove the rear header trim. See Headliner Trim - Rear Header Trim (Remove and Install).
  12. Remove the LH cantrail trim. See Headliner Trim - Cantrail Trim - LH (Remove and Install).
  13. Remove the LH 2nd row seat back outboard bolster. See 2nd Row Seat Assemblies - 2R Seat Side Bolster LH (Remove and Install).
  14. Fold the LH and RH 2nd row seats to the up position.
  15. Partially release the LH rear primary door seal.
  16. Remove the LH lower C-pillar trim. See A-B-C Post Interior Trim - C-Pillar Lower Trim - LH (Remove and Install).
    Informational PurposesAn informational icon, calling your attention
    Note
    Leave the trim attached to the seatbelt.
  17. Remove the LH lower B-pillar trim. See A-B-C Post Interior Trim - B-Pillar Lower Trim - LH (Remove and Install).
  18. Remove the LH upper B-pillar trim. See A-B-C Post Interior Trim - B-Pillar Upper Trim - LH (Remove and Install).
  19. Remove the bolt that attaches the LH front seat belt guide to the vehicle, and then remove the guide from the vehicle.
    10 Nm (7.4 lbs-ft)
    Tip: Use of the following tool(s) is recommended:
    • 10 mm socket

Install

  1. Position the LH front seat belt guide into the vehicle, and then install the bolt that attaches the guide to the vehicle.
    10 Nm (7.4 lbs-ft)
    Tip: Use of the following tool(s) is recommended:
    • 10 mm socket
  2. Install the LH upper B-pillar trim. See A-B-C Post Interior Trim - B-Pillar Upper Trim - LH (Remove and Install).
  3. Install the LH lower B-pillar trim. See A-B-C Post Interior Trim - B-Pillar Lower Trim - LH (Remove and Install).
  4. Install the LH lower C-pillar trim. See A-B-C Post Interior Trim - C-Pillar Lower Trim - LH (Remove and Install).
  5. Install the LH rear primary door seal.
  6. Fold the LH and RH 2nd row seats down.
  7. Install the LH 2nd row seat back outboard bolster. See 2nd Row Seat Assemblies - 2R Seat Side Bolster LH (Remove and Install).
  8. Install the LH cantrail trim. See Headliner Trim - Cantrail Trim - LH (Remove and Install).
  9. Install the rear header trim. See Headliner Trim - Rear Header Trim (Remove and Install).
  10. Install the LH lower A-pillar trim. See A-B-C Post Interior Trim - A-Pillar Lower Trim - LH (Remove and Install).
  11. Install the LH side lower A-pillar primary seal.
  12. Install the LH upper A-pillar trim. See A-B-C Post Interior Trim - A-Pillar Upper Trim - LH (Remove and Install).
  13. Install the LH mid A-pillar trim. See A-B-C Post Interior Trim - A-Pillar Mid Trim - LH (Remove and Install).
  14. Install the front header trim. See Headliner Trim - Front Header Trim (Remove and Install).
  15. Reconnect MV power. See Disconnect MV Power.
  16. Install the rear underhood apron. See Underhood Trim - Rear Apron Assembly (Remove and Install).
  17. Raise all the windows and close all the doors.