2024-07-23

Fairing - Rocker Panel - Rear - LH (Remove and Replace)

Correction code 12202202 FRT 0.18 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.

Warning IconA warning icon, calling your attention to a possibly risky situation
Warning
This procedure is a DRAFT. Although it has been validated, Warnings and Cautions might be missing. Follow safety requirements and use extreme caution when working on or near High Voltage systems and components. Provide corrections and feedback to ServiceDevelopment@teslamotors.com.

Remove

  1. Remove the LH rocker assembly from the vehicle. See Rocker Panel Trim - Rocker Assembly - LH (Remove and Install).
  2. Remove the screws (x4) that attach the LH rocker panel fairing to the rocker assembly, and then release the tabs (x3) to remove the fairing from the assembly.
    2 Nm (1.5 lbs-ft)
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • Torx T20 socket

Install

  1. Position the LH rocker panel fairing to the rocker assembly, engage the tabs (x3), and then install the screws (x4) that attach the fairing to the assembly.
    2 Nm (1.5 lbs-ft)
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • Torx T20 socket
  2. Install the LH rocker assembly. See Rocker Panel Trim - Rocker Assembly - LH (Remove and Install).