2026-08-09

Door - Charge Port (Remove and Replace)

Correction code 4401024032 FRT 0.30 NOTE: Unless otherwise explicitly stated in the procedure, the correction code and its associated FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. NOTE: See Personal Protection to make sure you are wearing proper PPE when performing the procedure below. NOTE: See Ergonomic Precautions for safe and healthy working practices.

Warning
This procedure is a DRAFT. Although it has been validated, Warnings and Cautions might be missing. Follow safety requirements and use extreme caution when working on or near High Voltage systems and components.

Install

  1. Install the charge port door, but do not exit Service Mode. See Door - Charge Port (Remove and Install).
  2. Reinstall the vehicle software.
    Note
    On the UI, navigate to Service Mode UI > Software Reinstall > Reinstall. Installation will begin immediately.
  3. Exit Service Mode. See Service Mode.
  4. Verify operation of the vehicle charging system.
    Note
    Make sure the light illuminates green to indicate charging has started.
  5. Raise the LH front window and close the LH front door.