2024-07-23

Rocker Panel Trim - Front Rocker Step Reinforcement - LH (Remove and Install)

Correction code 1220105061 1220105062 FRT 0.18 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.

Warning IconA warning icon, calling your attention to a possibly risky situation
Warning
This procedure is a DRAFT. Although it has been validated, Warnings and Cautions might be missing. Follow safety requirements and use extreme caution when working on or near High Voltage systems and components. Provide corrections and feedback to ServiceDevelopment@teslamotors.com.

Remove

  1. Remove the LH rocker assembly. See Rocker Panel Trim - Rocker Assembly - LH (Remove and Install).
  2. Remove the bolts (x3) that attach the LH front rocker step reinforcement to the vehicle, and then remove the reinforcement from the vehicle.
    15 Nm (11.1 lbs-ft)
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • 10 mm socket

Install

  1. Position the LH front rocker step reinforcement to the vehicle, and then install the bolts (x3) that attach the reinforcement to the vehicle.
    15 Nm (11.1 lbs-ft)
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • 10 mm socket
  2. Install the LH rocker assembly. See Rocker Panel Trim - Rocker Assembly - LH (Remove and Install).