2026-04-02

Lamp - Tailgate (Remove and Install)

Correction code 1740115061 FRT 0.30 NOTE: Unless otherwise explicitly stated in the procedure, the correction code and FRT listed above reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. NOTE: See Personal Protection to make sure you are wearing proper PPE when performing the procedure below. NOTE: See Ergonomic Precautions for safe and healthy working practices.

  • 2026-04-02: Added steps to install and remove masking tape to tailgate to protect the panel during install.
Warning IconA warning icon, calling your attention to a possibly risky situation
Warning
This procedure is a DRAFT. Although it has been validated, Warnings and Cautions might be missing. Follow safety requirements and use extreme caution when working on or near High Voltage systems and components.

Remove

  1. Remove the tailgate inner cover. See Cover - Inner - Tailgate (Remove and Install).
  2. Remove the bolts (x8) that attach the tailgate lamp to the tailgate, disconnect the electrical connectors (x2), release the harness clips (x2) and then remove the tailgate lamp from the tailgate.
    5 Nm (3.7 lbs-ft)
    Informational PurposesAn informational icon, calling your attention
    Note
    Assistance is recommended.
    Informational PurposesAn informational icon, calling your attention
    Note
    Gently pry up on the lip to release the lamp from the tailgate.
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • Torx T30 socket

Install

  1. Install masking tape onto the tailgate upper lip to protect the panel during install.
  2. Position the tailgate lamp to the tailgate, connect the electrical connectors (x2), secure the harness clips (x2), and then install the bolts (x8) that attach the tailgate lamp to the tailgate.
    5 Nm (3.7 lbs-ft)
    Informational PurposesAn informational icon, calling your attention
    Note
    Assistance is recommended.
    Informational PurposesAn informational icon, calling your attention
    Note
    Push the lamp assembly inward past the tailgate upper lip.
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • Torx T30 socket
  3. Remove the tape from the tailgate upper lip.
  4. Install the tailgate inner cover. See Cover - Inner - Tailgate (Remove and Install).