07/11/2024 13:41:02

Windshield Washer Bottle and Pump - Washer Tank Assembly (Remove and Install)

Correction code NEW NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.

  • 2024-10-7: Added step to fill washer tank with washer fluid after install.
Warning IconA warning icon, calling your attention to a possibly risky situation
Warning
This procedure is a DRAFT. Although it has been validated, Warnings and Cautions might be missing. Follow safety requirements and use extreme caution when working on or near High Voltage systems and components. Provide corrections and feedback to ServiceDevelopment@teslamotors.com.

Remove

  1. Remove the frunk assembly. See Frunk Assembly (Remove and Install).
  2. Release the clip that attaches the windshield wiper washer hose to the megabeam washer hose, and then disconnect the hoses.
  3. Release the clip that attaches the camera nozzle hose to the washer pump, and then disconnect the hose from the washer pump.
  4. Release the harness clips (x2) from the washer tank assembly.
  5. Disconnect the washer pump electrical connector.
  6. Disconnect the washer level sensor electrical connector.
  7. Remove the bolts (x3) that attach the washer tank assembly to the vehicle, and then remove the assembly from the vehicle.
    Tip: Use of the following tool(s) is recommended:
    • 10 mm socket

Install

  1. Position the washer tank assembly into the vehicle, and then install the bolts (x3) that attach the assembly to the vehicle.
    8 Nm (5.9 lbs-ft)
    Tip: Use of the following tool(s) is recommended:
    • 10 mm socket
  2. Connect the washer level sensor electrical connector.
  3. Connect the washer pump electrical connector.
  4. Secure the harness clips (x2) to the washer tank assembly.
  5. Connect the camera nozzle hose to the washer pump, and then secure the clip.
  6. Connect the megabeam windshield washer hose to the washer hose assembly, and then secure the clip.
  7. Install the frunk assembly. See Frunk Assembly (Remove and Install).
  8. Fill washer tank with washer fluid.