Lamp - Frunk (Remove and Install)
Correction code
1224057031
FRT
0.12
NOTE: Unless
otherwise explicitly stated in the procedure, the above correction code and
FRT reflect all of the work required to perform this procedure, including
the linked procedures. Do
not stack correction codes unless explicitly told to do so.
NOTE: See Flat Rate Times to learn more about FRTs and how they are
created. To provide feedback on FRT values, email ServiceManualFeedback@tesla.com.
NOTE: See Personal Protection to make
sure wearing proper PPE when performing the below procedure. See Ergonomic Precautions for safe and healthy
working practices.
Remove
- Remove the powergate fascia assembly. See Assembly - Powergate Fascia (Remove and Install).
-
Release the clips (x2) that attach the
frunk lamp to the vehicle, disconnect the electrical connector, and then remove the lamp
from the vehicle.
Install
-
Position the frunk lamp into the
vehicle, connect the electrical connector, and then secure the clips (x2) that attach
the lamp to the vehicle.
- Install the powergate fascia assembly. See Assembly - Powergate Fascia (Remove and Install).