2026-08-09

Rear Energy Absorber - Fascia Step Bracket - Center (Remove and Install)

Correction code 1001094021 FRT 0.42 NOTE: Unless otherwise explicitly stated in the procedure, the correction code and its associated FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. NOTE: See Personal Protection to make sure you are wearing proper PPE when performing the procedure below. NOTE: See Ergonomic Precautions for safe and healthy working practices.

Warning
This procedure is a DRAFT. Although it has been validated, Warnings and Cautions might be missing. Follow safety requirements and use extreme caution when working on or near High Voltage systems and components.

Remove

  1. Remove the rear fascia assembly. See Rear Fascia (Remove and Install).
  2. Remove the clips (x3) that attach the rear center step bracket to the vehicle, and then remove the bracket from the vehicle.

Install

  1. Position the rear center step bracket to the vehicle, and then install the clips (x3) that attach the bracket to the vehicle.
  2. Install the rear fascia assembly. See Rear Fascia (Remove and Install).