23/07/2024 17:31:09
High Voltage Battery Assembly - Rear Skid Plate Assembly (Remove and Install)
Correction code 1601070131 1601070132 FRT 0.18 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.
Warning
This procedure is a DRAFT. Although it has been validated, Warnings and Cautions might be missing. Follow safety requirements and use extreme caution when working on or near High Voltage systems and components. Provide corrections and feedback to ServiceDevelopment@teslamotors.com.
Remove
- Open the LH front door and lower the LH front window.
- Raise and support the vehicle. See Raise Vehicle - 2 Post Lift.
- Raise the vehicle to a comfortable working height.
-
Remove the clips (x6) and bolts (x10)
that attach the mid aeroshield to the vehicle, and then remove the aeroshield from the
vehicle.
TIpUse of the following tool(s) is recommended:
- 15 mm socket
- 13 mm socket
- 10 mm socket
Install
-
Position the mid aeroshield to the vehicle, and then install the bolts (x10) and
clips (x6) that attach the aeroshield to the vehicle.NoteApply Loctite 222 onto the bolts before installing.NoteThe 15 mm bolts (x3) are torqued to 42 Nm, the 13 mm bolts (x5) to 28 Nm, and the 10 mm bolts (x2) to 6 Nm.TIpUse of the following tool(s) is recommended:
- 15 mm socket
- 13 mm socket
- 10 mm socket
- Remove the vehicle from the lift. See Raise Vehicle - 2 Post Lift.
- Raise the LH front window and close the LH front door.