31/07/2024 09:50:47

Undertray - Mid Aeroshield (Remove and Install)

Correction code 1203128061 FRT 0.12 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.

Warning IconA warning icon, calling your attention to a possibly risky situation
Warning
This procedure is a DRAFT. Although it has been validated, Warnings and Cautions might be missing. Follow safety requirements and use extreme caution when working on or near High Voltage systems and components. Provide corrections and feedback to ServiceDevelopment@teslamotors.com.

Remove

  1. Raise and support the vehicle. See Raise Vehicle - 2 Post Lift.
  2. Open the LH front door and lower the LH front window.
  3. Raise the vehicle fully.
  4. Remove the bolts (x8) and clips (x6) that attach the mid aeroshield to the vehicle, and then remove the aeroshield from the vehicle.
    Tip: Use of the following tool(s) is recommended:
    • 15 mm socket
    • 13 mm socket
    • 10 mm socket

Install

  1. Position the mid aero shield onto the vehicle, and then install the bolts (x8) and clips (x6) that attach the aeroshield to the vehicle.
    70 Nm (51.6 lbs-ft)
    28 Nm (20.6 lbs-ft)
    6 Nm (4.4 lbs-ft)
    Informational PurposesAn informational icon, calling your attention
    Note
    Apply Loctite 222 onto the mid aero shield bolts, and then install the fasteners.
    Informational PurposesAn informational icon, calling your attention
    Note
    The torque value are as follows:
    • 15 mm bolts (x3) are torqued to 70 Nm
    • 13 mm bolts (x3) are torqued to 28 Nm
    • 10 mm bolts (x2) are torqued to 6 Nm
    Tip: Use of the following tool(s) is recommended:
    • 15 mm socket
    • 13 mm socket
    • 10 mm socket
  2. Lower the vehicle until the tires are touching the ground.
  3. Remove the vehicle from the lift. See Raise Vehicle - 2 Post Lift.
  4. Raise the LH front window and close the LH front door.