2024-07-23

Cover - Footwell (Remove and Install)

Correction code 1405028111 1405028112 FRT 0.12 NOTE: Unless otherwise explicitly stated in the procedure, the correction code and FRT listed above reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. NOTE: See Personal Protection to make sure you are wearing proper PPE when performing the procedure below. NOTE: See Ergonomic Precautions for safe and healthy working practices.

Warning IconA warning icon, calling your attention to a possibly risky situation
Warning
This procedure is a DRAFT. Although it has been validated, Warnings and Cautions might be missing. Follow safety requirements and use extreme caution when working on or near High Voltage systems and components.

Remove

  1. Open the LH front door and lower the LH front window.
  2. Release the clips (x3) and magnets (x3) that attach the footwell cover to the vehicle, remove the bolt that attaches the tether to the vehicle, and then remove the cover from the vehicle.
    3 Nm (2.2 lbs-ft)
    Informational PurposesAn informational icon, calling your attention
    Note
    The bolt is captive to the tether.
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • 10 mm socket

Install

  1. Position the footwell cover into the vehicle, install the bolt that attaches the tether to the vehicle, and then secure the clips (x3) and magnets (x3) that attach the cover to the vehicle.
  2. Raise the LH front window and close the LH front door.