23/07/2024 17:34:50

Tail Lights - Body Side Tail Lamp - LH (Remove and Install)

Correction code 1740115031 FRT 0.18 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.

Warning IconA warning icon, calling your attention to a possibly risky situation
Warning
This procedure is a DRAFT. Although it has been validated, Warnings and Cautions might be missing. Follow safety requirements and use extreme caution when working on or near High Voltage systems and components. Provide corrections and feedback to ServiceDevelopment@teslamotors.com.

Remove

  1. Remove the LH rear lamp closeout applique. See Truck Bed Exterior Trim - Rear Lamp Closeout Applique - LH (Remove and Install).
  2. Remove the LH rear bed closeout. See Truck Bed - Rear Bed Closeout - LH (Remove and Install).
  3. Remove the screws (x2) that attach the LH body side tail lamp to the vehicle, disconnect the electrical connector, and then remove the tail lamp from the vehicle.
    5 Nm (3.7 lbs-ft)
    Informational PurposesAn informational icon, calling your attention
    Note
    After removing the screws, gently pry the tail lamp away from body to release the datums.
    Informational PurposesAn informational icon, calling your attention
    Note
    Release the connector lock before disconnecting the connector.
    Tip: Use of the following tool(s) is recommended:
    • Torx T30 socket

Install

  1. Position the LH body side tail lamp to the vehicle, connect the electrical connector and engage the connector lock, and then install the screws (x2) that attach the tail lamp to the vehicle.
    5 Nm (3.7 lbs-ft)
    Informational PurposesAn informational icon, calling your attention
    Note
    Push the tail lamp forward to engage the datums.
    Tip: Use of the following tool(s) is recommended:
    • Torx T30 socket
  2. Install the LH rear bed closeout. See Truck Bed - Rear Bed Closeout - LH (Remove and Install).
  3. Install the LH rear lamp closeout applique. See Truck Bed Exterior Trim - Rear Lamp Closeout Applique - LH (Remove and Install).