01/08/2024 14:29:37

Exterior Mirrors - Exterior Mirror Assembly - Electromechanical - LH (Remove and Install)

Correction code 1209034051 FRT 0.12 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.

  • 2024-08-01: Updated step to discard bolts after removal.
Warning IconA warning icon, calling your attention to a possibly risky situation
Warning
This procedure is a DRAFT. Although it has been validated, Warnings and Cautions might be missing. Follow safety requirements and use extreme caution when working on or near High Voltage systems and components. Provide corrections and feedback to ServiceDevelopment@teslamotors.com.

Remove

  1. Open the LH front door and lower the LH front window.
  2. Remove the door panel plug, release the connector lock, and then disconnect the LH exterior mirror assembly connector.
    Informational PurposesAn informational icon, calling your attention
    Note
    Push the harness inside the door once it is released.
  3. Release the retaining plugs (x3) to partially release the door belt seal.
  4. Remove and discard the bolts (x3) that attach the LH exterior mirror assembly to the door, and then lift the mirror assembly upward to remove it.
    18 Nm (13.3 lbs-ft)
    Warning IconA warning icon, calling your attention to a possibly risky situation
    CAUTION
    Make sure the harness is not caught inside door.
    Tip: Use of the following tool(s) is recommended:
    • Torx T40 socket

Install

  1. Lower the LH exterior mirror assembly into the door, and then install new bolts (PN: 1857466-00-B) (x3) that attach the mirror to the door.
    18 Nm (13.3 lbs-ft)
    Informational PurposesAn informational icon, calling your attention
    Note
    Make sure the harness is accessible at the door plug before installing the bolts.
    Tip: Move the belt seal as needed for access.
    Tip: Use of the following tool(s) is recommended:
    • Torx T40 socket
  2. Move the door belt seal back into position, and then secure the retaining plugs (x3).
  3. Connect the LH exterior mirror assembly connector, engage the connector lock, and then install the door panel plug.
  4. Raise the LH front window and close the LH front door.