19/12/2024 10:08:04

Steering Column and Wheel - Steering Wheel Pur Heated (Remove and Install)

Correction code 3205111021 FRT 0.18 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.

  • 2024-12-19: Added caution to make sure the steering wheel is level during removal and installation.
  • 2024-08-02: Added warning not to rotate SCCM during removal of the steering wheel.
Warning IconA warning icon, calling your attention to a possibly risky situation
Warning
This procedure is a DRAFT. Although it has been validated, Warnings and Cautions might be missing. Follow safety requirements and use extreme caution when working on or near High Voltage systems and components. Provide corrections and feedback to ServiceDevelopment@teslamotors.com.

Remove

  1. Open the LH front door and lower the LH front window.
  2. Remove the rear underhood apron. See Underhood Trim - Rear Apron Assembly (Remove and Install).
  3. Disconnect MV power. See Disconnect MV Power.
  4. Remove the driver airbag. See Front Air Bags - Driver Airbag Assembly (Remove and Install).
  5. Disconnect the steering wheel electrical connector.
  6. Remove and discard the bolt that attaches the steering wheel to the vehicle, and then pull the steering wheel assembly straight back to remove it.
    Warning IconA warning icon, calling your attention to a possibly risky situation
    CAUTION
    DO NOT rotate the SCCM during removal of the steering wheel. Rotating the SCCM during removal will cause damage to the SCCM internals. Use masking tape to tape the SCCM into position to prevent it from rotating.
    Warning IconA warning icon, calling your attention to a possibly risky situation
    CAUTION
    Make sure the steering wheel is level before removal.
    Tip: Use of the following tool(s) is recommended:
    • 10 mm hex
    • 3 in extension

Install

  1. Align the steering wheel splines onto shaft, and then install a new bolt that attaches the steering wheel to the vehicle.
    80 Nm (59.0 lbs-ft)
    Warning IconA warning icon, calling your attention to a possibly risky situation
    CAUTION
    Do NOT rotate steering wheel until vehicle is powered on.
    Warning IconA warning icon, calling your attention to a possibly risky situation
    CAUTION
    Make sure the steering wheel is positioned level during installation.
    Tip: Use of the following tool(s) is recommended:
    • 10 mm hex
    • 3 in extension
  2. Connect the steering wheel electrical connector.
  3. Install the driver airbag. See Front Air Bags - Driver Airbag Assembly (Remove and Install).
  4. Reconnect MV power. See Disconnect MV Power.
  5. Install the rear underhood apron. See Underhood Trim - Rear Apron Assembly (Remove and Install).
  6. Raise the LH front window and close the LH front door.