2026-08-09

Carrier - Fender Flare - Fore - Rear - LH (Remove and Install)

Correction code 1220043101 FRT 0.12 NOTE: Unless otherwise explicitly stated in the procedure, the correction code and its associated FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. NOTE: See Personal Protection to make sure you are wearing proper PPE when performing the procedure below. NOTE: See Ergonomic Precautions for safe and healthy working practices.

Warning
This procedure is a DRAFT. Although it has been validated, Warnings and Cautions might be missing. Follow safety requirements and use extreme caution when working on or near High Voltage systems and components.

Remove

  1. Remove the LH rear fore fender flare. See Fender Flare - Fore - Rear - LH (Remove and Install).
  2. Remove the clips (x5) that attach the LH rear wheel liner to the LH rear fore fender flare carrier.
  3. Remove the bolts (x7) that attach the LH rear fore fender flare carrier to the vehicle, disconnect the LH rear BLE electrical connector, and then remove the carrier from the vehicle.
    7 Nm (5.2 lbs-ft)
    Tip
    Use of the following tool(s) is recommended:
    • 10 mm socket

Install

  1. Position the LH rear fore fender flare carrier to the vehicle, connect the LH rear BLE electrical connector, and then install the bolts (x7) that attach the carrier to the vehicle.
    7 Nm (5.2 lbs-ft)
    Tip
    Use of the following tool(s) is recommended:
    • 10 mm socket
  2. Install the clips (x5) that attach the LH rear wheel liner to the LH rear fore fender flare carrier.
  3. Install the LH rear fore fender flare. See Fender Flare - Fore - Rear - LH (Remove and Install).