ABS Module and ESC Sensor - Wheel Speed Sensor - Rear - LH (Remove and Install)
Correction code
3310007071
3310007072
FRT
0.18
NOTE: Unless
otherwise explicitly stated in the procedure, the above correction code and
FRT reflect all of the work required to perform this procedure, including
the linked procedures. Do
not stack correction codes unless explicitly told to do so.
NOTE: See Flat Rate Times to learn more about FRTs and how they are
created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com.
NOTE: See Personal Protection to make
sure wearing proper PPE when performing the below procedure.
Remove
- Open the LH front door and lower the LH front window.
- Raise and support the vehicle. See Raise Vehicle - 2 Post Lift.
- Remove the LH rear wheel. See Wheel Assembly (Remove and Install).
-
Remove the bolt that attaches the LH
rear wheel speed sensor to the LH rear knuckle, release the connector lock and
disconnect the electrical connector, and then remove the sensor from the vehicle.8 Nm (5.9 lbs-ft)TIpUse of the following tool(s) is recommended:
- Torx T30 socket
Install
-
Position the LH rear wheel speed
sensor to the LH rear knuckle, connect the electrical connector and engage the connector
lock, and then install the bolt that attaches the sensor to the knuckle.8 Nm (5.9 lbs-ft)TIpUse of the following tool(s) is recommended:
- Torx T30 socket
- Install the LH front wheel. See Wheel Assembly (Remove and Install).
- Remove the vehicle from the lift. See Raise Vehicle - 2 Post Lift.
- Raise the LH front window and close the LH front door.