23/07/2024 17:26:17
Brake Pedal - Accelerator Pedal Support Bracket (Remove and Install)
Correction code
3325020031
3325020032
FRT
0.12
NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so.
NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com.
NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.
Warning
This procedure is a DRAFT. Although it has been validated, Warnings and Cautions might be missing. Follow safety requirements and use extreme caution when working on or near High Voltage systems and components. Provide corrections and feedback to ServiceDevelopment@teslamotors.com.
Remove
- Open the LH front door and lower the LH front window.
- Move the LH front seat fully rearward.
- Remove the accelerator pedal side trim. See Passenger Compartment Carpet - Pedal - Side Trim (Remove and Install).
- Remove the accelerator pedal. See Brake Pedal - Brake Pedal - Option (Remove and Install).
-
Lift the accelerator pedal support
bracket off the studs, and then remove the support bracket from the vehicle.
Install
-
Position the accelerator pedal support
bracket into the vehicle.
- Install the accelerator pedal. See Brake Pedal - Brake Pedal - Option (Remove and Install).
- Install the accelerator pedal side trim. See Passenger Compartment Carpet - Pedal - Side Trim (Remove and Install).
- Restore the LH front seat back to its original position.
- Raise the LH front window and close the LH front door.