2025-01-13

Exterior Door Switch - Front - LH (B-Pillar) (Remove and Install)

Correction code 1245011001 FRT 0.12 NOTE: Unless otherwise explicitly stated in the procedure, the correction code and FRT listed above reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. NOTE: See Personal Protection to make sure you are wearing proper PPE when performing the procedure below. NOTE: See Ergonomic Precautions for safe and healthy working practices.

  • 2025-01-13: Updated fastener size to T20.
Warning IconA warning icon, calling your attention to a possibly risky situation
Warning
This procedure is a DRAFT. Although it has been validated, Warnings and Cautions might be missing. Follow safety requirements and use extreme caution when working on or near High Voltage systems and components.

Remove

  1. Remove the LH B-pillar applique. See Applique - B-Pillar - LH (Remove and Install).
  2. Disconnect the connector, release the grommet that attaches the LH door trigger harness to the LH B-pillar applique, and then feed the harness through the applique opening.
  3. Remove the bolts (x2) that attach the LH door trigger to the B-pillar applique, and then remove the door trigger through the front of the applique.
    3 Nm (2.2 lbs-ft)
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • Torx T20 socket

Install

  1. Position the LH door trigger to the B-pillar applique, feed the harness through the front of the applique opening, and then install the bolts (x2) that attach the door trigger to the applique.
    3 Nm (2.2 lbs-ft)
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • Torx T20 socket
  2. Feed the door trigger harness through the applique opening, secure the grommet, and then connect the electrical connector.
  3. Install the LH B-pillar applique. See Applique - B-Pillar - LH (Remove and Install).