2024-07-23

Frunk Switch (Remove and Install)

Correction code 1001052041 1001052042 FRT 0.12 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.

Warning IconA warning icon, calling your attention to a possibly risky situation
Warning
This procedure is a DRAFT. Although it has been validated, Warnings and Cautions might be missing. Follow safety requirements and use extreme caution when working on or near High Voltage systems and components. Provide corrections and feedback to ServiceDevelopment@teslamotors.com.

Install

  1. Position the frunk switch into the vehicle, and then engage the tabs (x2) that attach the switch to the vehicle.
    Informational PurposesAn informational icon, calling your attention
    Note
    Make sure the switch is fully seated in the applique assembly.
  2. Install the front center applique assembly. See Front Grille and Applique - Front Center Applique Assembly (Remove and Install).
  3. Install the frunk assembly. See Frunk Assembly (Remove and Install).
  4. Install the rear underhood apron. See Underhood Apron - Rear (Remove and Install).
  5. Raise the LH front window and close the LH front door.