23/07/2024 17:28:29

Forward Facing - Heated Fascia Camera Trinity (Remove and Install)

Correction code 1722037011 FRT 0.12 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.

Warning IconA warning icon, calling your attention to a possibly risky situation
Warning
This procedure is a DRAFT. Although it has been validated, Warnings and Cautions might be missing. Follow safety requirements and use extreme caution when working on or near High Voltage systems and components. Provide corrections and feedback to ServiceDevelopment@teslamotors.com.

Remove

  1. Open the LH front door and lower the LH front window.
  2. Put the vehicle in Service Mode. See Service Mode.
  3. Remove the front license plate dummy cover. See Front Bumper Fascia - Front Fascia Lower Dummy LP Cover (Remove and Install).
  4. Disconnect the front fascia camera heater electrical connector.
    Informational PurposesAn informational icon, calling your attention
    Note
    Pull the locking tab, and then push to release the electrical connector.
  5. Remove the screws (x2) that attach the front fascia camera cover to the front fascia.
    2 Nm (1.5 lbs-ft)
    Tip: Use of the following tool(s) is recommended:
    • PH1
  6. Remove the screws (x2) that attach the front fascia camera to the front fascia.
    0.7 Nm (6 lbs-in)
    Tip: Use of the following tool(s) is recommended:
    • T8
  7. Disconnect the camera coax cable, and then remove the camera from the front fascia.
    Informational PurposesAn informational icon, calling your attention
    Note
    Disconnect the coax cable after the camera is removed from the front fascia.
    Informational PurposesAn informational icon, calling your attention
    Note
    Avoid pinching cables.

Install

  1. Install the camera to the front fascia.
    Informational PurposesAn informational icon, calling your attention
    Note
    Connect the coax cable before the camera is installed.
    Warning IconA warning icon, calling your attention to a possibly risky situation
    CAUTION
    Avoid pinching cables.
    Informational PurposesAn informational icon, calling your attention
    Note
    Manipulate as needed to position.
  2. Install the screws (x2) that attach the front fascia camera to the front fascia.
    0.7 Nm (6 lbs-in)
    Tip: Use of the following tool(s) is recommended:
    • T8
  3. Install the screws (x2) that attach the front fascia camera cover to the front fascia.
    2 Nm (1.5 lbs-ft)
    Tip: Use of the following tool(s) is recommended:
    • PH1
  4. Connect the front fascia camera heater electrical connector.
    Informational PurposesAn informational icon, calling your attention
    Note
    Engage the locking tab.
  5. Install the front license plate dummy cover. See Front Bumper Fascia - Front Fascia Lower Dummy LP Cover (Remove and Install).
  6. Unlock the vehicle gateway. See Gateway (Unlock).
  7. Clear the camera calibration using the vehicle touchscreen.
    Informational PurposesAn informational icon, calling your attention
    Note
    While in Service Mode, touch Driver Assist > Cameras > Clear Camera Calibration > Camera Input > ForwardFacing and touch Run.
  8. Raise the LH front window and close the LH front door.