31/07/2024 09:11:20

Exterior Trim Fittings - Roof Applique Bracket (Remove and Install)

Correction code 1220035091 FRT 0.06 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.

  • 2024-07-31: Updated step for installing the bracket and securing the fastener.
Warning IconA warning icon, calling your attention to a possibly risky situation
Warning
This procedure is a DRAFT. Although it has been validated, Warnings and Cautions might be missing. Follow safety requirements and use extreme caution when working on or near High Voltage systems and components. Provide corrections and feedback to ServiceDevelopment@teslamotors.com.

Remove

  1. Remove the LH roof applique. See Exterior Trim Fittings - Roof Applique - LH (Remove and Install).
  2. Remove the fastener that attaches the LH roof applique bracket to the vehicle, and then remove the bracket from the vehicle.
    Informational PurposesAn informational icon, calling your attention
    Note
    Use a phillips screwdriver to turn the fastener counter clockwise 45 degrees, lift to release the fastener, and then pry the bracket upwards to remove it.

Install

  1. Position the LH roof applique bracket into the vehicle, and then push the red fastener downward until an audible click is heard.
    Informational PurposesAn informational icon, calling your attention
    Note
    Make sure the fastener is in the open position before installing the bracket into the vehicle.
    Informational PurposesAn informational icon, calling your attention
    Note
    Push the fastener downwards only when the bracket is fully seated into the vehicle.
    Informational PurposesAn informational icon, calling your attention
    Note
    Perform a push-pull-push test to ensure the bracket is fully secured.
  2. Install the LH roof applique. See Exterior Trim Fittings - Roof Applique - LH (Remove and Install).