07/08/2024 14:14:51

Exterior Trim Fittings - Roof Applique - LH (Remove and Install)

Correction code 1220035221 FRT 0.06 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.

Warning IconA warning icon, calling your attention to a possibly risky situation
Warning
This procedure is a DRAFT, although it has been validated. Warnings and Cautions might be missing. Follow safety requirements and use extreme caution when working on or near high voltage systems and components. Provide corrections and feedback to ServiceDevelopment@teslamotors.com.

Remove

  1. Release the clips (x5) that attach the LH roof applique to the vehicle, and then remove the applique from the vehicle.

Install

  1. Position the LH roof applique onto the vehicle, and then secure the clips (x5) that attach the applique to the vehicle.
    Informational PurposesAn informational icon, calling your attention
    Note
    There will be an audible click when the applique is fully installed.
    Informational PurposesAn informational icon, calling your attention
    Note
    Replace any missing or damaged clips.