Link - Stabilizer Bar - Front - LH (Remove and Install)
Correction code
3101062021
3101062022
3101062031
3101062032
FRT
0.24
NOTE: Unless
otherwise explicitly stated in the procedure, the above correction code and
FRT reflect all of the work required to perform this procedure, including
the linked procedures. Do
not stack correction codes unless explicitly told to do so.
NOTE: See Flat Rate Times to learn more about FRTs and how they are
created. To provide feedback on FRT values, email ServiceManualFeedback@tesla.com.
NOTE: See Personal Protection to make
sure wearing proper PPE when performing the below procedure. See Ergonomic Precautions for safe and healthy
working practices.
- 2025-07-18: Added torque spec caution for the Front Stabilizer Link based on part number revision.
Remove
- Open the LH front door and lower the LH front window.
- Raise and support the vehicle. See Raise Vehicle - 2 Post Lift.
- Remove the LH front wheel. See Wheel Assembly (Remove and Install).
-
Remove and discard the nuts (x2) that attach the LH stabar link to the vehicle, and then remove the link from the vehicle.275 Nm (202.8 lbs-ft)NoteCounter hold the stud as needed.TIpUse of the following tool(s) is recommended:
- 21 mm socket
Install
-
Position the LH stabar link into the vehicle, and then install new nuts (x2) that attach the link to the vehicle.275 Nm (202.8 lbs-ft)CAUTIONStabar link part number ending in 00-C or later must be torqued to 210 Nm +/-10 only at the upper stabar link fastener.NoteCounter hold the stud as needed.TIpUse of the following tool(s) is recommended:
- 21 mm socket
- Install the LH front wheel. See Wheel Assembly (Remove and Install).
- Remove the vehicle from the lift. See Raise Vehicle - 2 Post Lift.
- Open the LH front door and lower the LH front window.