Tailgate Latch and Striker - LH Tailgate Cinching Latch (Remove and Install)
Correction code 1133116041 FRT 0.18 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.
Remove
- Remove the tailgate inner cover. See Truck Bed - Tailgate Inner Cover (Remove and Install).
-
Release the latching bracket and cable
stay to release the LH manual release cable.
NoteRelease latch on bracket, then slide inboard to release. Pivot the cable stay 90 degrees to release it from the latch.
-
Release the connector lock, and then disconnect the LH tailgate cinching latch
electrical connector.
-
Remove the bolts (x2) that attach the
LH tailgate cinching latch to the vehicle, and then remove the latch assembly from the
vehicle.Tip: Use of the following tool(s) is recommended:
- Torx T40 socket
Install
-
Position the LH tailgate cinching latch to the vehicle, and then install the bolts
(x2) that attach the latch assembly to the vehicle.Tip: Use of the following tool(s) is recommended:
- Torx T40 socket
-
Connect the LH tailgate cinching latch electrical connector, and then secure the
connector lock.
-
Maneuver the LH manual release cable into the vehicle, install the cable stay to the
latch, and then secure the latching bracket.
- Install the tailgate inner cover. See Truck Bed - Tailgate Inner Cover (Remove and Install)