2024-10-31

Windshield Washer Bottle and Pump - Mega Beam - Washer Hose Assembly (Remove and Install)

Correction code NEW NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.

Warning IconA warning icon, calling your attention to a possibly risky situation
Warning
This procedure is a DRAFT. Although it has been validated, Warnings and Cautions might be missing. Follow safety requirements and use extreme caution when working on or near High Voltage systems and components. Provide corrections and feedback to ServiceDevelopment@teslamotors.com.

Remove

  1. Remove the frunk assembly. See Frunk Assembly (Remove and Install).
  2. Release the clip that attaches the windshield wiper washer hose to the megabeam washer hose, and then disconnect the hoses.
  3. Release the clip that attaches the windshield wiper washer hose to the wiper motor assembly hose, and then disconnect the hoses.
  4. Release the clips (x6) that attach the megabeam windshield washer hose to the vehicle, and then remove the hose from the vehicle.

Install

  1. Position the megabeam windshield washer hose into the vehicle, and then secure the clips that attach the hose to the vehicle.
  2. Connect the megabeam windshield washer hose to the wiper motor assembly hose, and then secure the clip.
  3. Connect the megabeam windshield washer hose to the washer hose assembly, and then secure the clip.
  4. Install the frunk assembly. See reFrunk Assembly (Remove and Install).