23/07/2024 17:23:39
2nd Row Seat Covers and Pads - 2R Backrest Insert Trim (Remove and Install)
Correction code 1308005081 1308005082 FRT 0.84 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.
Warning
This procedure is a DRAFT. Although it has been validated, Warnings and Cautions might be missing. Follow safety requirements and use extreme caution when working on or near High Voltage systems and components. Provide corrections and feedback to ServiceDevelopment@teslamotors.com.
Remove
- Remove the LH 2nd row seat back assembly. See 2nd Row Seat Assemblies - 2nd Row Seat Back Assembly - LH (Remove and Install).
-
Release the plastic retainers (x11),
hooks (x8), clips (x4), and Velcro strip that attach the LH 2nd row back rest insert
trim to the seat back assembly, and then remove the trim from the assembly.
NoteRelease the clips from rear, and then pull the trim off the assembly to access the remaining clips and Velcro.
Install
-
Position the LH 2nd row seat back
insert trim to the seat back assembly, and then fasten the clips (x4), hooks (x8),
plastic retainers (x11), and Velcro strip that attach the trim to the assembly.
NoteSecure the Velcro strips and clips to the front of the seat back, and then manipulate the trim into position, securing the retainers and hooks.
- Install the LH 2nd row seat back assembly. See 2nd Row Seat Assemblies - 2nd Row Seat Back Assembly - LH (Remove and Install).