23/07/2024 17:29:45

Front Fascia, Front Gate and Fem Harnesses - Harness, Front Gate (Remove and Install)

Correction code 1710051021 1710051022 FRT 0.48 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.

Warning IconA warning icon, calling your attention to a possibly risky situation
Warning
This procedure is a DRAFT. Although it has been validated, Warnings and Cautions might be missing. Follow safety requirements and use extreme caution when working on or near High Voltage systems and components. Provide corrections and feedback to ServiceDevelopment@teslamotors.com.

Remove

  1. Open the LH front door and lower the LH front window.
  2. On the vehicle touchscreen, navigate to UI > Controls > Ride Height > Very High to set the air suspension ride height to “Very High”.
  3. On the vehicle touchscreen, navigate to Controls > Service > Jack Mode to place the air suspension into "Jack Mode".
  4. Remove the rear underhood apron. See Underhood Trim - Rear Apron Assembly (Remove and Install).
  5. Disconnect MV power. See Disconnect MV Power.
  6. Remove the frunk assembly. See Frunk Assembly (Remove and Install).
  7. Remove the LH and RH lightbar beauty covers. See Exterior Trim Fittings - Lightbar Beauty Cover - LH (Remove and Install).
  8. Remove powered front trunk fascia. See Closure Panels - Assembly - Powergate Fascia (Remove and Install).
  9. Release the clips (x9) that attach the front gate harness to the powered frunk, and then release the connector lock and disconnect the electrical connectors (x2).
  10. Remove the RH front wheel liner. See Wheel Arch Liners - Front Wheel Liner - LH (Remove and Replace).
  11. Release the connector lock and disconnect the front gate harness electrical connector, release the clips (x3) that attach the harness to the vehicle, and then remove the harness from the vehicle.
    Informational PurposesAn informational icon, calling your attention
    Note
    Images show the fender removed for clarity.

Install

  1. Position the front gate harness into the vehicle, install the clips (x3) that attach the harness to the vehicle, and then connect the electrical connector and engage the connector lock.
    Informational PurposesAn informational icon, calling your attention
    Note
    Images show the fender removed for clarity.
  2. Install the RH front wheel liner. See Wheel Arch Liners - Front Wheel Liner - LH (Remove and Replace).
  3. Install the clips (x9) that attach the front gate harness to the powered frunk, and then connect the electrical connectors (x2) and engage the connector locks.
  4. Install the powered front trunk fascia. See Closure Panels - Assembly - Powergate Fascia (Remove and Install).
  5. Install the LH and RH lightbar beauty covers. See Exterior Trim Fittings - Lightbar Beauty Cover - LH (Remove and Install).
  6. Reconnect MV power. See Disconnect MV Power.
  7. Install the frunk assembly. See Frunk Assembly (Remove and Install).
  8. Install the rear underhood apron. See Underhood Trim - Rear Apron Assembly (Remove and Install).
  9. On the vehicle touchscreen, navigate to Controls > Service > Jack Mode to remove the air suspension from "Jack Mode".
  10. On the vehicle touchscreen, navigate to UI > Controls > Ride Height > Medium to set the air suspension ride height to “Medium”.
  11. Raise the LH front window and close the LH front door.