Axle Seal - Output - Rear Drive Unit (Remove and Install)
Correction code
4001093011
4001093012
FRT
0.54
NOTE: Unless
otherwise explicitly stated in the procedure, the correction code and its
associated FRT reflect all of the work required to perform this procedure,
including the linked procedures. Do not stack correction
codes unless explicitly told to do so.
NOTE: See Flat Rate Times to
learn more about FRTs and how they are created.
NOTE: See Personal Protection to make
sure you are wearing proper PPE when performing the procedure below.
NOTE: See Ergonomic Precautions for safe and healthy
working practices.
Remove
- Open the LH front door and lower the LH front window.
- Raise and support the vehicle on a 2 post lift. See Raise Vehicle - 2 Post Lift.
-
Use the vehicle touchscreen to enable
Tow Mode.
NoteAllow drive rails to completely turn on before enabling.
- Remove the LH rear halfshaft. See Halfshaft - Rear Drive Unit - LH (Remove and Install).
-
Use a seal puller to remove the LH
rear halfshaft output seal.
TipUse of the following tool(s) is recommended:
- Adjustable Seal Puller - 1454928-00-A
Install
-
Install the LH rear halfshaft output
seal to the seal driver, and then position the seal square to the rear drive unit
bore.
- Install the LH rear halfshaft. See Halfshaft - Rear Drive Unit - LH (Remove and Install).
- Use the vehicle touchscreen to exit Tow Mode.
- Remove the vehicle from the lift. See Raise Vehicle - 2 Post Lift.
- Raise the LH front window and close the LH front door.