23/07/2024 17:34:16

Steering Column and Wheel - Shroud Upper Instrument Panel - Steering Column (Remove and Install)

Correction code 3205111051 3205111052 FRT 0.71 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.

Warning IconA warning icon, calling your attention to a possibly risky situation
Warning
This procedure is a DRAFT. Although it has been validated, Warnings and Cautions might be missing. Follow safety requirements and use extreme caution when working on or near High Voltage systems and components. Provide corrections and feedback to ServiceDevelopment@teslamotors.com.

Remove

  1. Open the LH front door and lower the LH front window.
  2. Move the steering wheel fully forward and to the lowest position.
  3. Release the clips (x4) that attach the steering column upper shroud to the steering column, and then remove the shroud from the steering column.

Install

  1. Position the steering column upper shroud onto the steering column, and then engage the clips that attach the shroud to the steering column.
  2. Move the steering wheel back to its original position.
  3. Raise the LH front window and close the LH front door.