23/07/2024 17:28:14

Exterior Trim Fittings - Closeout - LH (Remove and Install)

Correction code 1220035011 FRT 0.06 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.

Warning IconA warning icon, calling your attention to a possibly risky situation
Warning
This procedure is a DRAFT. Although it has been validated, Warnings and Cautions might be missing. Follow safety requirements and use extreme caution when working on or near High Voltage systems and components. Provide corrections and feedback to ServiceDevelopment@teslamotors.com.

Remove

  1. Open the LH doors and lower the LH front window.
  2. Release the clips (x2) that attach the LH B-pillar applique closeout to the B-pillar, and then remove the closeout from the B-pillar.

Install

  1. Position the LH B-pillar applique closeout to the B-pillar, and then secure the clips (x2) that attach the closeout to the B-pillar.
  2. Close the LH doors and raise the LH front window.